Open Power Supply Detail Photos

AC input-Photo   AC Input
Unplugs for easy wire installation.
110 volt shown.
220 / 230 volt optional.

Ground Lug

12 / 24 volt DC Switch
Select output voltage range
for 12 or 24 volt brakes & clutches.

Output-Photo  
Output Connector

Unplugs for easy wire installation.

% CURRENT POT
   For manual control

0-10 INPUT
   Output current is proportional to 0-10 volt signal input

OUTPUT  -  +
   For brake or clutch wires


Ammeter Connector

Active on PS-M models only.
Output connector  &  Ammeter connector
PS Switch-Photo  
1 <---->2 SWITCH  (Blue)
1 - Manual (potentiometer) control
2 - 0-10v control

SPAN MAX Potentiometer
Sets output current range.

REMOTE SPAN plug
For cable for remotely mounted Span Max. potentiometer.
For tension adjustments on constant tension winding systems when using a Follower Arm Potentiometer or Ultrasonic sensor.

SWITCH SW3  (Red)
To select internal or remote Span Max. potentiometer.
Part Numbers
Input Part Number
110 Volts A.C. PS-(voltage) - M
220 Volts A.C. PS-(voltage) - M2
Specify output voltage --- 12 or 24 volts D.C.
home.gifReturn to Main Page